Building a wooden fence is a one-time task and one you can’t replay even if you want to. Although people go with the usual wooden fence, have you ever pondered the idea in the long run? Your traditional wooden fence with fence posts, even the pressure-treated ones, might last for a good 20 years before the time for wear and tear begins to appear. Now a fence with metal posts might cost you a bit more than your usual budget, but it could last up to 70 years which is more than three times the life expectancy of the traditional wooden fence. You can consult Paint for Wood Fence on PaintCatalogue , if you are looking to choose the best one.
But the benefits don’t stop there! The fence with wood posts can stand wind to a certain point before starting to break from the base after the wood gets compromised by aging. The opposite is true for the metal post as they can withstand much more pressure. When the fence with wood posts age, they start to lean and curve inwards. You won’t have to face this issue with metal posts. Along with the long-lasting abilities, a wooden fence with metal posts would also have lower lifetime maintenance costs. Enough with the benefits, are you ready to learn how to build your wooden fence with metal posts?
The following are steps to DIY your wooden fence with metal posts:
- First, you should remove all kinds of trees, shrubs, and vines from the fence line.
- When you have selected your fence line, you should mark it using pegs dug to the ground at both fence ends. You can use the mason line to make sure that the fence line is not curved anywhere. The line would be a measuring scale when you are setting fence posts and erecting the panels.
- By utilizing the recommended spacing of your fence manufacturers, you should mark areas to be holed for posts.
- You have to dig up a hole of at least 600mm or two feet with the help of a post hole digger, auger, or a double-ended shovel. The depth of the hole can be dependant on the type of soil you are digging for it.
- You should ensure that the metal posts are plumb and in-line when you place them in the holes. You can hold the posts in a temporary bracing to ensure that they stay in place while you dry-fit the fence.
- You can dry-fit the posts by using temporary fasteners such as removable clamps on two or three posts. You can grade, excavate and fill the area as requires when you move along the fence line.
- You can repeat the dry fitting process a second time to confirm that the grading is secure.
- Use the plumb and posts driving tool or a block and hammer to fix the posts to the depth you desire. The height of the posts should be in sync with your panels.
- You can set the posts a bit higher than the required height so that there is a space to allow the post to be capped.
- You can even place the caps before the posts and rails are secured by the panels.
- Afterward, you have to secure the posts to the temporary bracing after the replumbing is done.
- Follow the instructions on the bag to mix the concrete.
- You have to fill the holes in the ground with cement until you are one inch below ground level.
- The concrete should be allowed enough time to set. The setting time is dependant on the dampness of the ground and the cement mix you have used.
- You can now install the horizontal rails after leveling them and screwing them on your rails. The height should be kept the same if you are looking at a sloping grade.
- If your fence is 48 to 60 inches tall, the bottom rail should be kept 6 inches above the ground, while the top rail can be kept four inches below the panel top.
- If your fence is taller than the above measurements, you should place an intermediate rail between the center of the top and bottom.
- You can then fasten the rails on the metal posts on any design you want.