Car locking keys are normally metal keys that ensure your entrance into your own car. Not just entrance, it also helps you to switch on your car and lock your doors while necessary. It assures the safety of your car while you are not close to it.
Car locks generally use ignition key and some other door panel and locks as well as metal rods to incorporate with the car. Car locks need changing when it gets damaged for heavy rain or other issues and stolen. Sometimes you may face problems regarding how to change a car lock immediately.
Step by Step Guideline on How to Change a Car Lock Immediately
People often find car lock changing a very time consuming and difficult task. It may also cost a lot. If you know some techniques, it will be easier for you to change a car lock in the shortest possible time. Here goes a step by step guideline on how to change a car lock immediately:
Step-1: Taking the Door Panel Aside
The first and foremost step of changing a car lock is to take the door panel aside. So, in order to change your car lock, first, you have to put your ignition key on position so that you can successfully elevate the window up. After elevating the window up, put the window off and gently take the door panel aside. Now you can go closer to the backside of the lock for removing it.
Step-2: Lifting the Window Up
After removing the door panel, you need to put on the ignition key once again to lift up the window in the possible highest place which is already connected with a wire. Once you lift the window up to your expected high position and put the ignition key off.
Step-3: Carrying the Inner Liner Away
A plastic liner is there to preserve water so that it cannot enter into any inner parts of the car. You need to hold the plastic liner on and smoothly carry it away. Tighten it with the glue and keep it for further use when the lock changing will over.
Step-4: Diverging the Door Handle Control Rod
During the time of handling the inner door, find out the main door handle control rod and diverge it carefully. You can also repair the broken clip by which the control rod was attached to the inner door at the same time.
Step-5: Putting the Lock Control Rod Out
Now you will need a screwdriver using which you have to put the lock control rod out after you have found it once. Push the clip of the control rod downward for removing the rod from the lock arm.
Step-6: Unbarring Inner Handle
Take a wrench or a socket of 10mm and unbar the inner handle of the car by pushing the mounting bolts of the handle lock anticlockwise. You may also use a mounting bolt access hole to unbar the lock more easily.
Step-7: Ejecting Outer Door Handle
Once you have finished removing the inner handle, go for ejecting the outer one. You may need some pushing it for ejection. Make sure not to scratch.
Step-8: Dispelling the Door Lock
Finally, you are closer to the door lock. Take a pick or screwdriver to dispel the power clip holding the door lock inside the lock hole. Then you can effortlessly take off the lock cylinder which would become loose just after the removal of the power clip.
Step-9: Fixing New Door Lock
In this step, fix a new door lock instead of the old key. In order to use the old one, you can repair it by a locksmith. Take a locking clip to attach it into the right place.
Step-10: Putting New Outer Door Handle Rod Clip
Put a new outer door handle rod clip being careful to take it identical to the older clip. Afterwards, shift all the lock clips that are broken.
Step-11: Attaching Outer Door Handle
Finally, attach a new outer door handle very diligently. And your car is ready to drive with the new door lock.
Conclusion
With these steps, you will be able to change or replace your car locks very quickly. The steps are so easy and tricky that you can do it all by yourself, which will give you relief from the high repairing cost. You can check out the manual given by the owner or seller of the car instructing all details about the vehicle. It will increase both your knowledge and skill while changing the locks.
