If you are fishing for bass, then there are few lures more versatile than thelipless crankbait. These lures can be used in pretty much any situation where you would normally be fishing for bass. This means that you can use the same lure whether you are fishing in the sea, lakes, or even rivers.
The lipless crankbait isn’t even a difficult lure to use. Let’s take a look, shall we?
What is a Lipless Crankbait?
The purpose of a lure like this is to cause vibrations in the water. The vibrations are meant to simulate that a small fish is swimming about the area. The way in which you move the crankbait could even simulate an injured fish which, of course, is going to encourage the bass to come in. Most of them would love a helpless meal. It is a tasty snack for them!
The vibrations are caused by the wobbling of the lure as you retrieve it. This means that it should be constantly on the move. We will talk more about that in a short while.
Where should you be using a lipless crankbait?
As we said before, one of the perks of this type of lure is that it can be used pretty much anywhere that you find bass. The bass always seem to be attracted to it.
The areas where this lure really seems to thrive, however, is when it is used in an area that is heavy in vegetation. This is because the bass tend to be looking for smaller fish here anyway, and thus your lure is going to be quite appealing to them.
As you use the crankbait, you will find that the way in which you use it will vary based upon where you are fishing.
How to use this type of lure for bass
When you cast this lure, it will start to sink in the water. This is why it is so versatile. It allows you to fish at a variety of different depths without any issues. It is important that you have a decent understanding about where those fish may be located beforehand, though. Remember, the depth of the bass will change depending on the weather and the temperature of the water.
The best way to use this lure is to simply cast it out as far as you can. Once it has been cast out, allow it to start sinking into the water. You should have a decent idea of where the fish are. If you don’t, then most people find success around the 10-foot deep mark.
You can then start to reel the lure back in. You don’t need to do anything special here. Try to keep the line as straight as possible and the lure will do all the hard work for you.
If you are casting into vegetation, then we suggest that you use it in a slightly different way. Rather than casting it and reeling it in slowly, cast it out and pull it back in fast. This will allow it to tear through the vegetation. This will send even more vibrations into the water. This, of course, will lead to an even greater bite rate.
Remember, always purchase the best lures that you can find. You will find that the better lures tend to move a lot more naturally in the water. This means that you will have a far, far easier time getting bites. This is especially important with a lipless because if it does not move like an actual fish, no bass will pay attention to it.
Leave a Reply