A car dolly is an essential tool for every garage. Especially if you have a couple of cars by using a car dolly, you can move your vehicle smoothly from one place to another.
For example, one of your car engines is not working, but you need to move your vehicle at the corner of your garage. That’s why you will need a car dolly to drive your car quickly.
You can purchase car dolly from any auto shop. However, if you want to save some dollars, then you can make your car dolly. You need to give some of your valuable time to finish the project.
In this article, I will be discussing how to make a wheel cat dolly on your own.
Make a wheel car dolly of your own
Materials required
The first step of how to make a wheel car dolly is to gather all the required materials. Before starting the process, you need to make sure all the elements are near your hand.
The following materials are needed to make a wheel car dolly.
- Casters. Strong enough to carry a car
- Carriage bolts
- Nuts or washers
- Plywood sheet
- Sloid rubber wheels
These are the material you need to make a wheel car dolly. You will also need a drill machine and a hammer.
Cutting the plywood sheet
Once you have all the materials, you can begin the making process of a wheel car dolly. You can start by cutting the plywood sheet. Take a plywood sheet and cut the plywood by maintaining the square size.
Make sure you cut the plywood sheet big enough to fit a car tier. I recommend using three layers of plywood for each dolly. And to do that you have to cut all the plywood sheet precisely the same size.
After cutting all the pieces of plywood sheet, you will need a good quality glue to attach three layers of the plywood sheet. After attaching three layers with glue, you need to wait until those plywood sheets are correctly connected.
Attach the casters
After finishing cutting and glueing the plywood sheet, you can start attaching the casters. To attach the casters, you will have to choose where to install the casters. Because each dolly requires four casters and you have to place them correctly.
Once you are selecting the location of the casters, you can start installing them correctly. Make sure all the caster can rotate 360 degrees. Drill the holes accurately, put the nuts inside the hole and tighten the nuts with carriage bolts. Repeat the process for each dolly and make sure you do that correctly.
Test the Dolly
This is the final step of how to make a wheel car dolly. Making a car dolly is so much easier than you think. But the main concern is, it will this work properly after finishing the wheel car dolly making process.
That’s why you need to test the dolly on your own. To check the dolly, try moving your dolly. Make sure all the Casters are appropriately placed.
Otherwise, you will see your dolly is not working correctly. After that check how much weight your dolly can handle to identify the highest capacity of the dolly.
Give a proper finish.
You can give your dolly a proper finish after testing the whole set of dollies, like painting the dolly if you wish. Give the dolly a bit of polish to the sharp edge because it can hurt the tires by sharp edges.
Now you can use your dolly to drive your vehicle. Simply raise the car with the lifter and place the dollies under each wheel. When you’re done, you can drive your vehicle quickly wherever you want.
Conclusion
As I have said, car dolly is a handy garage tool. It allows the vehicle to be moved as you wish. But most people don’t want to spend the extra dollar just for a set of dollies because you don’t need car dolly to drive your car most of the time.
You don’t need to move your vehicle all of the time, to be honest. So if you think buying a package of dollies is just a waste of money, then you can make your dolly only by following the instructions above. I’ve already discussed in this article how to make dolly a wheel car. I hope the information above will help. Good ever.
